pedestal. After all, you can't go anywhere else right now, can
you? At the
pedestal, lower the platform a bit, by moving the red knob
clockwise around the
center.

See, the fan is turning now? Okay, so far, so good. Now, move
the red knob again
to the right, to reposition that first overhead gear back over on
the right side
in front of the painting. Then pull the red knob counterclockwise
to move the
platform to floor level and simultaneously drain out all the
molten lava. Whew!

The fan is now blowing the hot air necessary to inflate the air
ship, but you
need to move that overhead gear back over to the left and engage
it to complete
the process. Pass the redknob back through the center of the
pedestal.

Leave and go back up to the control room. At that pedestal, move
the red knob
counterclockwise. This action will raise the chamber platform
again and allows
the lava to flow back in. Now you have turbo hot blowing air.

Look up to see the open end of the ventilation shaft. Hop in and
skeedaddle out
... Далее >>